General information

Flatlock panel can be installed aligned or staggered and both horizontally and vertically or even at an angle. The panels should be installed on a vertical wall or soffit. The fa├žade system involves laying the panels on a compatible wooden framework or plywood fixed to the supporting structure (masonry or metal structure).

Panels can be square, rectangular or diamond shaped. The panels interlock into each other on the four sides and are secured with concealed fasteners and clips.

Areas of application

Suitable for both renovation projects and new buildings - Can be installed horizontally and vertically

Technical data

Thickness0.80 mm
Centre to centre375 - 285 mm
Weight excluding framework7.83kg/m2
LengthFrom 0.5 to 4 m
Width of the joint10 m
  • PIGMENTO Brown
  • Natural zinc


The panels are installed in a sequential order from bottom up. The panels are held in place using cleats which can be stainless steel, zinc or galvanised steel.

For larger panels galvanised steel cleats are recommended. The cleats should be fixed at a maximum of 330mm centres. For small diamond shaped panels the hems should be slightly notched thus allowing the cleat to sit securely. When installing large rectangular panels the short side should be fixed with a long fixing strip. It is recommended that screws be used to secure the cleats.

The use of nails offers significantly less resistance, but in the event of using nails, contractors are advised to use ring shank nails. The panels should be installed with the protective film in place.

Do you have a question or remark? Please, leave us a message.

This site is protected by reCAPTCHA and the Google. Privacy Policy and Terms of Service apply.